您好,歡迎訪問無錫合達電子設備有限公司官網!
0510-83212339
138-6181-2138
無錫合達電子設備有限公司
您的位置:首頁 > 新聞動態 > 行業知識
聯系我們

無錫合達電子設備有限公司

地址:無錫市惠山區恒新路3號
電話:138-6181-2138

咨詢熱線138-6181-2138

老化房是一款大型的環境試驗設備

發布時間:2018-12-14人氣:156

老化房是一款大型的環境試驗設備,可滿足大批量生產或實驗的試驗設備,造價高。因此老化房日常的維護是非常重要的!正確的日常維護可延長使用壽命!其維護保養的方式跟普通老化房相差不了多少, 定期檢查和維護可以使它保持最佳工作狀態。現介紹以下幾點供大家參考:

Aging room is a large-scale environmental test equipment, which can meet the needs of mass production or experiment, and has high cost. Therefore, the daily maintenance of aging room is very important! Correct routine maintenance can extend service life! Its maintenance method is not much different from the ordinary aging room. Regular inspection and maintenance can keep it in the best working state. Here are the following points for your reference:

一、應建立使用檔案,以方便維護維修。使用檔案應記錄老化房每次運行起止時間(日期)、試驗的種類、環境溫度,當系統發生故障時,應對故障現象作盡可能詳細的描述,對系統進行維護、維修的內容也應盡可能詳細地記錄。

1. Use files should be established to facilitate maintenance and repair. The use of archives should record the starting and ending time (date), type of test and environmental temperature of each operation of the aging room. When the system fails, the failure phenomena should be described as detailed as possible, and the contents of maintenance and maintenance of the system should also be recorded as detailed as possible.

二、長時間停機不用,會影響系統的有效使用壽命,因此,系統每10天至少要開機運行一次,不要在短時間內反復地使系統運行一停止,每小時啟動次數應小于5次,每次開一停時的時間,間隔不小于3rain,不要在低溫時打開步入式老化房的大門,以防止損壞門密封帶。

2. Long downtime will affect the effective service life of the system. Therefore, the system should be operated at least once every 10 days. Do not stop the system repeatedly in a short time. The number of start-ups per hour should be less than 5 times. The time between start-up and stop should be no less than 3 rain. Do not open the door of the walking aging room at low temperature to prevent damage to the door seal. Band.

三、須由專人操作維護。嚴格遵守系統操作規程,避免他人違章操作系統。

3. It must be operated and maintained by special personnel. Strictly abide by the operating rules of the system to avoid other people violating the operating system. 四、主箱體,使用中應注意保護,不可受到利器或鈍器的強力碰撞。

4. The main box should be protected from strong collision of sharp or blunt weapons.

五、每月定期進行一次主電源開關(漏電短路器)動作試驗,以確保此開關在滿足負載能力下作為漏電保護器之用。具體步驟為,首先請確認總電源開關打到“ON",即系統通電,然后請按試驗按鈕。若漏電斷路,器的開關桿落下來則此功能正常。

Fifth, the operation test of the main power switch (leakage short circuit) is carried out regularly every month to ensure that the switch can be used as leakage protector when the load capacity is satisfied. The specific steps are: first, make sure that the main power switch is on, that is, the system is energized, and then press the test button. If the leakage current breaks, the switch rod of the device falls down, the function is normal.

六、漏電開關的漏電、過載,短路保護特性均由制造廠整定,在使用中不可隨意調整,以免影響性能,漏電開關因短路斷開后,需檢查觸頭,若主觸頭燒損嚴重或有凹坑時,需進行維修。

6. The leakage, overload and short-circuit protection characteristics of the leakage switch are set by the manufacturer, and can not be adjusted at will in use to avoid affecting the performance. After the leakage switch is disconnected due to short-circuit, it is necessary to check the contacts. If the main contacts are severely burned or have pits, it needs to be repaired.

七、為確保冷卻水供水正常和清潔,每30天左右清洗一次制冷機冷卻水過濾器,清洗一次供水的冷卻水塔若當地空氣質量比較差,空氣中灰塵含量很高,一般應為7天左右清洗冷卻水塔蓄水池。

7. In order to ensure the normal and clean supply of cooling water, the cooling water filters of refrigerators should be cleaned every 30 days or so. If the local air quality of the cooling water tower is poor and the dust content in the air is high, the cooling water storage tank should be cleaned for about 7 days.

八、超溫保護器動作試驗。把超溫保護器溫度定到比箱體溫度低,若出現E0.0報警和蜂嗚聲,表示其功能正常。完成上述試驗后,應將溫度保護的設定值重新適當地設定,否則可能會造成不適當的中止。

8. Operation test of overtemperature protector. Set the temperature of the overtemperature protector to be lower than the temperature of the box. If E0.0 alarm and buzzing occur, the function of the overtemperature protector is normal. After completing the above test, the setting value of temperature protection should be reset appropriately, otherwise it may cause inappropriate suspension.

九、在老化房內放置的試驗產品離空氣調節通道的吸、排風口應有一定的距離,以免妨礙空氣的流量。

9. The test products placed in the aging room should be at a certain distance from the suction and exhaust outlets of the air-conditioning passage so as not to interfere with the air flow.

十、每年一次,用吸塵器清理除去配電室和水回路室灰塵。每個月一次,用干布清理吸干冷凍機組接水盤積水。

10. Once a year, use a vacuum cleaner to remove dust from the distribution room and water circuit room. Once a month, dry cloth is used to clean up the water on the receiving plate of the suction refrigeration unit.

辛苦整理!轉載請注明來自 http://www.vnmgex.live/show.asp?id=123

推薦資訊

138-6181-2138
黑龙江11选5任选5码最大遗漏